例句與造句

1. The necessity of angle displacement error control is also explained
   本文方法具有一般性，對類似工程有借鑒意義。
2. The influence of the detecting array on the spectrum signal is studied . a solution is put forward to correct the displacement error caused by width of the light activated element , when the sampling theorem is satisfied
   提出了在滿足采樣定理的前提下，采用頻域反卷積的方法來消除由像元寬度對光譜峰值定位造成的亞像元誤差。
3. By using the method of error analysis of mbs , the identification equation of geometric error parameters is derived and according to the condition that the rank of coefficient matrix of error measurement equation group must be full , we can get 18 terms geometric error of 3 - axis nc machine tools and three displacement error and three position error
   應用誤差辨識軟件，解得各測量點的十八個誤差參數，即每個運動方向的三個位移誤差和三個位置誤差，再根據實際情況獲得三項垂直度誤差，得到了所有的21項誤差。
4. With different clearance value , displacement curves and velocity curves of generalized coordinates as well as slider displacement error curves in a motion period are obtained . these curves are discussed . results show that if manufacturing cost is kept invariableness , in order to improve precision of mould - cuting , fitting precision of joint connecting the crank and coupler has priority to be considered to increase
   采用四階rong - kuta法求解連續接觸模型的動力學方程，得到了一個運動周期內運動副間隙取不同值時，各廣義坐標的位移、速度曲線和滑塊位移誤差曲線，并通過曲線分析，得出了要提高模切機主切機構精度，在相同加工成本條件下，應優先考慮提高曲柄與連桿鉸接處的配合精度的結論。
5. The analysis of precision about mould - cut main mechanism with clearances is advanced . on the basis of analysis of slider displacement error influenced by the crank length tolerance , the coupler length tolerance and clearances in revolute joints for mould - cut main mechanism , some reasonable suggestions about tolerance distribution of bars length and fitting precision of joints are put forward
   考慮運動副間隙對主切機構進行了精度分析，通過分析主切機構中各桿長誤差和運動副間隙對滑塊位移誤差的影響，對商標模切機設計初期桿長誤差分配和運動副間隙配合精度提出了合理的建議。
6. It's difficult to find displacement error in a sentence. 用displacement error造句挺難的